curve

Draw a bezier curve using the given coordinates, from x1,y1 to x2,y2. The curvature is set by the control points cx1,cy2 and cx2,cy2.

Options

All of these options support arrays and singleton expansion (except for range). See Squib Thinks in Arrays for deeper explanation.

x1

default: 0

the x-coordinate of the first endpoint. Supports Unit Conversion and XYWH Shorthands..

y1

default: 0

the y-coordinate of the first endpoint. Supports Unit Conversion and XYWH Shorthands..

x2

default: 5

the x-coordinate of the second endpoint. Supports Unit Conversion and XYWH Shorthands..

y2

default: 5

the y-coordinate of the second endpoint. Supports Unit Conversion and XYWH Shorthands..

cx1

default: 0

the x-coordinate of the first control point. Supports Unit Conversion and XYWH Shorthands..

cy1

default: 0

the y-coordinate of the first control point. Supports Unit Conversion and XYWH Shorthands..

cx2

default: 5

the x-coordinate of the second control point. Supports Unit Conversion and XYWH Shorthands..

cy2

default: 5

the y-coordinate of the second control point. Supports Unit Conversion and XYWH Shorthands..

fill_color

default: '#0000' (fully transparent)

the color or gradient to fill with. See Specifying Colors & Gradients.

stroke_color

default: :black

the color with which to stroke the outside of the shape. See Specifying Colors & Gradients.

stroke_width

default: 2

the width of the outside stroke. Supports Unit Conversion.

stroke_strategy

default: :fill_first

Specify whether the stroke is done before (thinner) or after (thicker) filling the shape.

Must be either :fill_first or :stroke_first (or their string equivalents).

dash

default: '' (no dash pattern set)

Define a dash pattern for the stroke. This is a special string with space-separated numbers that define the pattern of on-and-off alternating strokes, measured in pixels or units. For example, '0.02in 0.02in' will be an equal on-and-off dash pattern. Supports Unit Conversion.

cap

default: :butt

Define how the end of the stroke is drawn. Options are :square, :butt, and :round (or string equivalents of those).

join

default: :mitre

Specifies how to render the junction of two lines when stroking. Options are :mitre, :round, and :bevel.

range

default: :all

the range of cards over which this will be rendered. See Using range to specify cards

layout

default: nil

entry in the layout to use as defaults for this command. See Layouts are Squib’s Best Feature.

Examples